Generic 91203-3 — Fault Code Guide
Official Description: End position Lift/Lowering, calibration The operation is used for calibrating the lift/lowering end positions. The operation should be performed when the following components have been replaced or adjusted: Angle sensor for the lifting arms.
Recommended Replacement Part: Replacement Sensor Or Valve
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Generic Replacement Parts on FridayParts →
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Generic Replacement Parts on FridayParts →
Quick Diagnostic Checklist
- Inspect Harness & Connectors: Check for loose pins, corrosion, oil contamination, or chafed wires near the replacement sensor or valve.
- Verify Supply Voltage & Ground: Test reference voltage (typically 5V or 12V/24V depending on circuit) with a multimeter.
- Test or Replace Component: If wiring tests good and code 91203-3 remains active, replace the replacement sensor or valve and clear logged codes.
Source reference: VOLVO-L180G-WHEEL-LOADER-Service-Repair-Manual.pdf (Page 1)