Generic Diagnostic Fault Codes (23)
- 90001-3 — MID 249 ECU, programming When changing ECU or only reprogramming
- 90002-3 — MID 249 ECU, campaign Used when there is a campaign on HW or SW.
- 91202-3 — Lift/Lower, calibration complete The operation is used for calibrating the lift/lowering function. The operati
- 91203-3 — End position Lift/Lowering, calibration The operation is used for calibrating the lift/lowering end positions.
- 91204-3 — Tilt In/Out, calibration complete The operation is used for calibrating the tilt function. The operation shoul
- 91205-3 — End position Tilt In/Out, calibration The operation is used for calibrating the tilt end positions. The operat
- 91310-3 — Hydraulic pump P3, hydraulic pressure, adjust The purpose of the operation is to by controlling the hydraulic
- 91311-3 — LS (load sensing) pressure, sensor value, check The operations reads the LS-pressure (Load sensing pressure) t
- 91402-3 — Electric servo Lift-/Lower, test The purpose of the test is to check the function of the components and connec
- 91403-3 — Electric servo Tilt In-/Out, test The purpose of the test is to check the function of the components and conne
- 91404-3 — Electric servo 3:rd function, test The purpose of the test is to check the function of the components and conn
- 91405-3 — Electric servo 4:th function, test The purpose of the test is to check the function of the components and conn
- 91408-3 — Angle sensor values, lift and tilt function check The purpose of this test is to see the dependence between li
- 91411-3 — Float position function, current, check Float position function, current, check is used to check the current r
- 91601-3 — 3:rd function, calibration The operation is used for calibrating the 3:rd function. The operation should be pe
- 91602-3 — 4:th function, calibration
- 91207-3 — Lift and lower function, current values, adjust This operation makes it possible to make individual adjustment
- 91208-3 — Tilt function, current values, adjust This operation makes it possible to make individual adjustments between
- 91611-3 — 3rd function, current values, adjust This operation makes it possible to make individual adjustments between M
- 91612-3 — 4th function, current values, adjust This operation makes it possible to make individual adjustments between M
- 92402-3 — Attachment lock, test The purpose of the test is to check the function of the switch and solenoid
- 17030-3 — Parameter, programming. Save all
- 64595-3 — Electric servo