Heavy Codes — Diagnostic Directory
Generic CAT_HYPHEN

Generic 91205-3 — Fault Code Guide

Official Description: End position Tilt In/Out, calibration The operation is used for calibrating the tilt end positions. The operation is to be performed when some of the following components have been replaced or adjusted: Angle sensor for the lifting arms, angle sensor for the tilt.

Recommended Replacement Part: Replacement Sensor Or Valve
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Generic Replacement Parts on FridayParts →

Quick Diagnostic Checklist

  1. Inspect Harness & Connectors: Check for loose pins, corrosion, oil contamination, or chafed wires near the replacement sensor or valve.
  2. Verify Supply Voltage & Ground: Test reference voltage (typically 5V or 12V/24V depending on circuit) with a multimeter.
  3. Test or Replace Component: If wiring tests good and code 91205-3 remains active, replace the replacement sensor or valve and clear logged codes.

Source reference: VOLVO-L180G-WHEEL-LOADER-Service-Repair-Manual.pdf (Page 1)

Related Generic Fault Codes