HeavyMachineryCodes.com
Kubota DTC

Kubota P0088 — Fault Code Guide

Official Description: 157 0 Engine Injector Metering Rail 1 Pressure Actual pressure exceeds the command pressure - Rail pressure sensor is normal - Sensor supply voltage VCC# is normal Actual pressure is 197 MPa (2010 kgf/cm2, 28600 psi) or more one sec or more Output limitation: Approximately 50% of normal condition Speed limitation (Accelerator limitation: 50%) EGR stop Intake throttle 100% open To minimize PM emission to DPF ON - Insufficient output - Worsening exhaust gas emissions Diagnostic counter = zero 30 s

Recommended Replacement Part: Egt Exhaust Gas Temperature Sensor
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Kubota Replacement Parts on FridayParts →

Quick Diagnostic Checklist

  1. Inspect Harness & Connectors: Check for loose pins, corrosion, oil contamination, or chafed wires near the EGT exhaust gas temperature sensor.
  2. Verify Supply Voltage & Ground: Test reference voltage (typically 5V or 12V/24V depending on circuit) with a multimeter.
  3. Test or Replace Component: If wiring tests good and code P0088 remains active, replace the EGT exhaust gas temperature sensor and clear logged codes.

Source reference: Codes Défaut KUBOTA.pdf (Page 1)

Related Kubota Fault Codes