Kubota P0089 — Fault Code Guide
Official Description: 1347 7 Engine Fuel Pump Pressurizing Assembly #1 SCV stuck at open position (Actual rail pressure continuously exceeds the command rail pressure) - Supply pump is normal and pump calibration has been executed - Engine is operating (Q: 4 mm3/st or more) - Injector is normal - Battery voltage is normal - Sensor supply voltage VCC# is normal - Rail pressure sensor is normal Discharge request of supply pump goes 0 mm3/st or less and the actual rail pressure is 10 MPa (100 kgf/cm2, 1400 psi) more tha
Recommended Replacement Part: Egt Exhaust Gas Temperature Sensor
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Kubota Replacement Parts on FridayParts →
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Kubota Replacement Parts on FridayParts →
Quick Diagnostic Checklist
- Inspect Harness & Connectors: Check for loose pins, corrosion, oil contamination, or chafed wires near the EGT exhaust gas temperature sensor.
- Verify Supply Voltage & Ground: Test reference voltage (typically 5V or 12V/24V depending on circuit) with a multimeter.
- Test or Replace Component: If wiring tests good and code P0089 remains active, replace the EGT exhaust gas temperature sensor and clear logged codes.
Source reference: Codes Défaut KUBOTA.pdf (Page 1)