Kubota P0102 — Fault Code Guide
Official Description: 132 4 Engine Inlet Air Mass Flow Rate Open circuit or ground short circuit of sensor or harness - Battery voltage is normal - Starter switch signal (ECU: V12 terminal) is not activated - Sensor supply voltage is normal Mass air flow sensor voltage: 0.1 V or less 2.8 sec or more Sensor output: 0.7 times of target value at normal condition [default value] Output limitation: Approximately 75% of normal condition EGR stop Intake throttle 100% open Engine is not stopped forcibly by ECU However KUBOTA
Recommended Replacement Part: Egt Exhaust Gas Temperature Sensor
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Kubota Replacement Parts on FridayParts →
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Kubota Replacement Parts on FridayParts →
Quick Diagnostic Checklist
- Inspect Harness & Connectors: Check for loose pins, corrosion, oil contamination, or chafed wires near the EGT exhaust gas temperature sensor.
- Verify Supply Voltage & Ground: Test reference voltage (typically 5V or 12V/24V depending on circuit) with a multimeter.
- Test or Replace Component: If wiring tests good and code P0102 remains active, replace the EGT exhaust gas temperature sensor and clear logged codes.
Source reference: Codes Défaut KUBOTA.pdf (Page 7)