Kubota P2455 — Fault Code Guide
Official Description: 3251 3 After treatment 1 Diesel Particulate Filter Differential Pressure Open circuit or +B short circuit of sensor or harness - Battery voltage is normal - Sensor supply voltage VCC# is normal - Starter switch signal (ECU: V12 terminal) is not activated DPF differential pressure sensor voltage: 4.7 V or more 2.8 sec or more 0 kPa (0.0 kgf/cm2, 0.0 psi) [default value] Output limitation: Approximately 75% of normal condition ON - Key switch turn OFF ―
Recommended Replacement Part: Dpf Differential Pressure Sensor
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Kubota Replacement Parts on FridayParts →
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Kubota Replacement Parts on FridayParts →
Quick Diagnostic Checklist
- Inspect Harness & Connectors: Check for loose pins, corrosion, oil contamination, or chafed wires near the DPF differential pressure sensor.
- Verify Supply Voltage & Ground: Test reference voltage (typically 5V or 12V/24V depending on circuit) with a multimeter.
- Test or Replace Component: If wiring tests good and code P2455 remains active, replace the DPF differential pressure sensor and clear logged codes.
Source reference: Codes Défaut KUBOTA.pdf (Page 9)