HeavyMachineryCodes.com
Kubota DTC

Kubota P3001 — Fault Code Guide

Official Description: 3252 0 After treatment 1 Exhaust Gas Temperature 2 Preliminary FMI DOC is heated up due to unburned fuel - Other than during regeneration mode - Coolant temp. is 65 degC (149 degF) or more continues longer than 5min after engine starting T1 - T0 is 250 degC (482 degF) or more 60 sec or more Output limitation: Approximately 50% of normal condition Speed limitation (Accelerator limitation: 50%) EGR stop Intake throttle 100% open To minimize PM emission to DPF ON - Insufficient output Key switch tu

Recommended Replacement Part: Egt Exhaust Gas Temperature Sensor
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Kubota Replacement Parts on FridayParts →

Quick Diagnostic Checklist

  1. Inspect Harness & Connectors: Check for loose pins, corrosion, oil contamination, or chafed wires near the EGT exhaust gas temperature sensor.
  2. Verify Supply Voltage & Ground: Test reference voltage (typically 5V or 12V/24V depending on circuit) with a multimeter.
  3. Test or Replace Component: If wiring tests good and code P3001 remains active, replace the EGT exhaust gas temperature sensor and clear logged codes.

Source reference: Codes Défaut KUBOTA.pdf (Page 9)

Related Kubota Fault Codes