HeavyMachineryCodes.com
Kubota DTC

Kubota P3004 — Fault Code Guide

Official Description: 3246 0 After treatment 1 Exhaust Gas Temperature 3 Preliminary FMI DPF outlet temp. (T2): High - Exhaust gas temp. sensor T0, T1 and T2 are normal - Battery voltage is normal DPF outlet temp. (T2): 820 degC (1508 degF) or more 2.0 sec or more Stop injection (Q = 0 mm3/st) Engine stop EGR stop Intake throttle 0% open (Close) Inhibit starter relay activation until exhaust temp. reduces down to 300 degC (572 degF) In case engine ECU is not involved to drive starter, starter activation should be inh

Recommended Replacement Part: Egt Exhaust Gas Temperature Sensor
Need to get your machine back on the job fast? Check OEM-quality aftermarket stock and pricing:
Shop Kubota Replacement Parts on FridayParts →

Quick Diagnostic Checklist

  1. Inspect Harness & Connectors: Check for loose pins, corrosion, oil contamination, or chafed wires near the EGT exhaust gas temperature sensor.
  2. Verify Supply Voltage & Ground: Test reference voltage (typically 5V or 12V/24V depending on circuit) with a multimeter.
  3. Test or Replace Component: If wiring tests good and code P3004 remains active, replace the EGT exhaust gas temperature sensor and clear logged codes.

Source reference: Codes Défaut KUBOTA.pdf (Page 10)

Related Kubota Fault Codes